OmniGraffle-Users digest, Vol 1 #10 - 6 msgs

[David Kasprzyk]

Hello Peter, Howard, and Jeremy:

Well, I finally was able to reproduce the error on one of my machines.  
I have tested the problem on several different machines (iBooks, G3 
towers, G4 towers) but it doesn't always occur.  Here's what I found.  
When I watched the zoom percentage as I clicked the zoom tool, sometimes 
the zoom would go from 100% to 200% and then 400% and then 800%.  
However, when I recreated the problem I started at 150% and not 100%. 
When I clicked with the zoom tool the zoom menu went blank. After that I 
zoomed again and it stayed blank but after the next click the window 
read 800%.  Therefore I think we are doubling the zoom percentage like;

	100 -> 200 -> 400 -> 800
	150 -> 300 -> 600 -> 800

With 800% as the maximum and since 300% and 600% aren't standard they 
don't display.  I think we should be displaying the percentage no matter 
if it is a standard value or not.

Sincerely,

David Kasprzyk
support at omnigroup.com

Join the OmniGraffle Users List
http://www.omnigroup.com/mailman/listinfo/omnigraffle-users

On Thursday, December 27, 2001, at 01:52  PM, Peter Stöhr wrote:

> Hi,
>

> Howard Kaufman wrote:
>
>> Yes I see the percentage there, but only when I select one of the 
>> preset values.  When I use the zoom tool to zoom to a specific 
>> selection the percentage value is completely blank.  This is in beta 
>> 2.0.3.  Check it out.
>>> Howard -
>>>
>>> I'm not sure if you mean something else, but I can see the zoom 
>>> percentage
>>> in the document window; it's in the bottom right corner, where the 
>>> scroll
>>> bars meet. It shows what zoom percentage I'm at currently, and serves 
>>> as a
>>> pop-up menu to let me select others. Is that what you're looking for?
>
>
> I just tried it and I had no problems ... The percentage value chagend 
> whenever I used to zoom tool to increase the zoom factor.
> I have beta 2.0.3 installed on 10.1.2.
>
> Greeting from Hof/Bavaria/Germany/Europe/Earth
>     Peter
>